Kaba RAC 4XT Installation Manual page 12

4. Route the card reader's wire through the
grommet of the back plate and assemble
the front of the reader onto the back plate.
Assemble together by tightening down
the screw (provided in the card reader's
installation bag) on the bottom of the card
reader.
5. Connect the card reader wire to the terminal
blocks of the controller PCB as per Annex
A, Table 1, or refer to Annex B, Figure 1.
IMPORTANT:
Ensure that the jumper wires are also
connected on the controller PCB.
NOTE: If required to differentiate between
ingress &
the appropriate connector on the
controller PCB is used.
Model R79-1N1
reader installation
Figure 13
1. Remove the back plate and use it to mark
the holes for the cables and screws.
Alternatively, the
512650 included with the reader can be
used.
NOTE: Do not use the actual drawing from
Annex G of this manual to mark the
hole locations as this drawing is not
to scale.
2. Drill the holes in the wall according to the
diameters indicated on the drilling template
in Annex G, based on the type of surface
the reader is being installed on.
Metal surface mounting: install the back
plate onto the wall with the metal screws
provided in the installation hardware bag.
Drywall surface
wall inserts (provided in the installation
hardware bag) into the wall using a rubber
mallet. Install the back plate onto the wall
with the wood screws provided.
INSTALLATION GUIDE - REMOTE ACCESS CONTROLLER RAC 4XT • PK3191_10_14
egress, ensure that
Contactless card
drilling template DT-
mounting: tap the
Page 11
3. Connect the included cable to the terminal
block of the reader as shown in Annex A,
Table 1. Ensure that the correct wire color
is attached to the correct terminal block
connection.
NOTE: For
additional
recommended to make a knot in the
cable close to the terminal block of
the reader.
4. Route the card reader's wire through the
grommet of the back plate and assemble
the front of the reader onto the back plate.
Assemble together by tightening down
the screw (provided in the card reader's
installation bag) on the bottom of the card
reader.
5. Connect the card reader wire to the terminal
blocks of the controller PCB as per Annex
A, Table 1, or refer to Annex B, Figure 2.
IMPORTANT:
Ensure that the jumper wires are also
connected on the controller PCB.
NOTE: If required to differentiate between
ingress &
the appropriate connector on the
controller PCB is used.
Model R71-6XX swipe card reader
Figure 14
J
1. Identify the location for the card reader and
drill a hole for the cable as per the drilling
template DT-512738 shown in Annex E, or
included with the card reader.
2. Remove the reader's enclosure, and route
the card reader wire through the hole. Use
the back plate of the reader to mark the
holes for the screws.
Alternatively the drilling template DT-512738
included with the reader can be used.
strain relief it
egress, ensure that
is