Manual Operation; Maintenance, Cleaning, Storing And Transport - Westfalia 81 77 21 Instruction Manual

Manual Operation

For manual operation you have to reposition the float switch at a higher level or to
keep the float switch up by hand. By doing this the water/liquid can be pumped up
completely. An automatic cutoff does not occur.
Do not operate the pump unsupervised during manual operation.
Disconnect the pump from power mains as soon as the water level falls below
5 cm. Otherwise, the pump will run dry long and can be damaged.

Maintenance, Cleaning, Storing and Transport

Unplug the power plug before undertaking any kind of maintenance work or
before cleaning.
The pump does not require maintenance apart from occasionally cleaning the
housing and the strainer.
When opening covers or removing casing parts you may expose live parts.
Capacitors inside the device may still carry voltage even though they have
been disconnected from all voltage sources.
Never use corrosive or acidic cleaners to clean the pump.
Keep the suction base (7) free from dirt and blockages of any kind to prevent
clogging.
Before storing thoroughly clean the turbine wheel; unscrew the four screws
from the bottom cover and remove the cover. Rinse all parts with clear water.
Store the pump in a dry place that is protected from dust, dirt and frost. Make
sure the pump is dry before storing it for long time.
The pump does not contain any parts serviceable by you. Do not disassemble
the pump and do not try to repair it yourself. Repairs must be done by a
professional only.
Carry the pump only by the carrying handle (1). Never carry, or lift up the
pump by the power cord.
Using
11