Dell EMC IDPA DP4400 Getting Started Manual page 22

Setting up the IDPA Appliance
Dell EMC Integrated Data Protection Appliance 2.4 Getting Started Guide
22
Note
Ensure that you click the prerequisites link available on the Welcome page and
read them before you continue.
a. In the Welcome page, select the Optional components that you want to
install in the configuration and click Next.
b. In the License page, the system automatically downloads the licenses for
Protection Storage, Backup Server, and Reporting and Analytics if you
are connected to the network.
c. Click Next.
Note
If you are not connected to the network, click Browse to locate and upload
the licenses.
d. In the General Settings page, perform the following actions.
a. Select the Time zone from the list.
b. Enter the IP address in the SMTP server and SNMP fields.
c. Select and enter the IP address in the IP address range (11) field.
Note
The system automatically assigns 11 IP addresses in chronological order
based on the IP address that you enter to configure the other components
of the appliance. For example, if you enter 10.200.1.10 the system
automatically generates a range of IP address from 10.200.1.10 to 20.
Note
If you do not select the IP address range (11) checkbox you must manually
configure and enter the IP addresses in the other sections. See Step
through Step 9
e. Click Validate.
The system validates the availability of the IP addresses and allocates them
to the IDPA components. To view the list of IP addresses allocated to the
individual components hover on the green check mark.
f. Click Next.
The Customer information page is displayed.
8. You can configure the settings manually. To configure the settings manually,
perform the following actions.
a. In the Protection storage configuration page, under the Data network
section, enter valid IP addresses for Backup IP 1 address and Backup IP 2
address.
b. In the Backup server page, enter valid IP addresses in the following.
8