Dell EMC IDPA DP4400 Getting Started Manual page 17

Subnet mask
IP address mask that identifies the range of IP addresses in the subnet
where the appliance is connected.
Note
The DP4400 supports only one network. Separate management, backup, or
replication network configurations (such as VLAN tagging) are not
supported.
Gateway
Default gateway IP address of the appliance.
Primary DNS server
The primary DNS server for your network environment.
Secondary DNS server
The secondary DNS server for your network environment.
Domain name
The domain name for your network environment.
Appliance Configuration Manager IP
The IP address to assign to the ACM. This is the first IP address of the 13
IPs that is reserved for the ACM.
ESXi IP
The IP address to assign to the ESXi server. This is the second IP address
of the 13 IPs that is reserved for ESXi.
NTP server IP
The NTP server IP address for your network environment.
2. Click Submit.
Results
After you configure basic networking, your web browser automatically redirects to
l
the ACM IP address assigned during network configuration.
Note
For automatic forwarding to work correctly, the computer you use to complete the
configuration must be connected to the same network as the configured ACM IP
address.
If you cannot have connections to both public and private networks at the same
l
time, disconnect from the private appliance configuration network and then
connect to the network that the ACM IP address is on to complete the rest of the
configuration.
Once the network configuration is complete, revert the network adapter IP
l
address settings on the service computer to their previous state.
Setting up the IDPA Appliance
Network Configuration wizard
17