TVT TD-9421E2B Quick Start Manual

Network Camera
Quick Start Guide
■ Please read this instruction carefully before operating the unit
and keep it for further reference.
■ All the examples and pictures used here are for reference only.
■ The contents of this manual are subject to change without
notice.
1

Warning and Caution

■ If the product does not work properly, please contact your dealer
or the nearest service center. Never attempt to disassemble the
camera yourself. (We shall not be responsible for any problems
caused by unauthorized repair or maintenance.)
■ Do not allow water or liquid intrusion into the water.
■ In the use of the product, you must be strict compliance with the
electrical safety regulations of the nation and region. When the
product is mounted on wall or ceiling, the device shall be firmly
fixed.
■ Do not use camera beyond specified voltage range.
■ Do not drop the camera or subject it to physical shock.
■ Avoid touching the camera lens.
■ If cleaning is necessary, please use clean cloth to wipe it gently.
If the device will not be used for a long time, please cover the lens
cap to protect the device from dirt.
■ Do not aim the camera at the sun or extra bright place.
■ Do not place the camera in extremely hot, cold (the operating
temperature shall be -30˚C~60˚C), dusty or damp locations, and
do not expose it to high electromagnetic radiation.
■ To avoid heat accumulation, good ventilation is required for
operating environment.
2

Package

Camera Quick start guide
CD
Drill Template
3

Overview

1 2
9
10
11
Fixed ring
7
1
Mounting base 8
2
Ethernet connector
9
3
10
4 CVBS output
5 Audio input
11
Power connector
6
DC12V
* 1 It is recommended to install the security cap for outdoor installation.
* 2 DC12V power supply is not required if a PoE switch is used to power the
camera.
► Connecting Network Cable
4 tapping screws PA 4×25
× 4
Plastic plug
1
① Loosen the nut from the main element.
② Run the network cable (without RJ 45 connector) through the
both elements. Then crimp the cable with RJ 45 connector.
3
③ Connect the cable to the hermetic connector. Then tighten the
4
nut and the main cover.
5
6
4

Installation

7
Please make sure that the wall or ceiling is strong enough to withstand
8
3 times the weight of the camera. Please install and use the camera in
the dry environment.
① Install a micro SD card. Remove the plastic cover (a) from the
Micro SD card slot
Reset camera and then loosen the two screws of (b). Remove (b) and then
SD card indicator
insert a micro SD card. After that, install back (b) and (a).
Power indicator
Network indicator
② Attach the drill template to the place where you want to fix the
camera and then drill the screw holes and the cable hole on the wall
according to the drill template.
2 3
a
b

Insert a micro SD card