Adjusting Alarm Volume - Mindray iPM Series Quick Manual

Setting the Date and Time
Select [Main Menu] →[Maintenance >>]→[System Time
1.
>>].
2. Set the date and time.
3. Select [Date Format] and toggle between [yyyy-mm-dd],
[mm-dd-yyyy] and [dd-mm-yyyy].
Select [Time Format] and toggle between [h] and [h].
4.
NOTE:
Changing date and time will affect the storage of trends

and events and may cause data missing.
Entering the Parameter Setup Menu
You can select the waveform area or parameter area to enter cor-
responding parameter setup menu.
Entering the Alarm Setup Menu
Select [Main Menu] →[Alarm Setup >>] to enter the alarm
1.
setup menu.
Basic Operations

Adjusting Alarm Volume

Select the [Volume Setup] QuickKey, or [Main Menu]→
1.
[Alarm Setup >>]→[Others].
Select [Alm Volume] and then select the appropriate vol-
2.
ume: X-10, in which X is the minimum volume, depending on
the set minimum alarm volume (refer to the chapter Alarm),
and 10 the maximum volume.
Adjusting Key Volume
1. Select the [Volume Setup] QuickKey, or [Main Menu]→
[Screen Setup >>].
Select [Key Volume] and then select the appropriate volume.
2.
0 means off, and 10 the maximum volume.
Adjusting QRS Volume
The QRS tone is derived from either the HR or PR, depending on
which is currently selected as the alarm source in [ECG Setup]
or [SpO Setup]. When monitoring SpO

tone which changes as the patient's saturation level changes. The
pitch of the tone rises as the saturation level increases and falls
as the saturation level decreases. The volume of this tone is user
adjustable.
1. Select the [Volume Setup] QuickKey, or the ECG parameter
window→[Others >>], or the SpO
Select [QRS Volume] or [Beat Vol] and then select the ap-
2.
propriate volume. 0 means off, and 10 the maximum volume.
, there is a variable pitch
2
parameter window.
2