Starting Monitoring; Disconnecting From Power - Mindray iPM Series Quick Manual

Getting Started
Turning Power on
1. Before you start to make measurements, check the patient
monitor and plug-in modules for any mechanical damage
and make sure that all external cables, plug-ins and accesso-
ries are properly connected.
2. Plug the power cord into the AC power source. If you run the
patient monitor on battery power, ensure that the battery is
sufficiently charged.
3. Press the power on/off switch on the monitor's front.

Starting Monitoring

1. Decide which measurements you want to make.
2. Connect the required modules, patient cables and sensors.
3. Check that the patient cables and sensors are correctly con-
nected.
4. Check that the patient settings such as [Patient Cat.], [Paced],
etc, are appropriate for your patient.
Refer to the appropriate measurement section for details of how
to perform the measurements you require.
Basic Operations

Disconnecting from Power

To disconnect the patient monitor from the AC power source,
follow this procedure:
1. Confirm that the patient monitoring is finished.
2. Disconnect the patient cables and sensors from the patient
monitor.
3. Make sure to save or clear the patient monitoring data as re-
quired.
4. Press and hold the power on/off switch. The patient monitor
shuts down and you can unplug the power cable.
NOTE:
Make sure that the operating environment of the equipment

meets the specific requirements. Otherwise unexpected
consequences, e.g. damage to the equipment, could
result.
Do not use the patient monitor for any monitoring

procedure on a patient if you suspect it is not working
properly, or if it is mechanically damaged. Contact your
service personnel or us.