Calibrating The Radar Sensor Without Magnetic Laser - Launch X-431 ADAS PRO User Manual

LAUNCH
*Caution: Laser radiation may cause damage to/destruction of the retina. Never look
directly into the laser beam.
7. Attach the magnetic laser onto the center of the radar reflector. Adjust the height of
the beam so that the laser beam is directed at the center of the radar sensor.
8. If the radar sensor has a mirror, the laser beam hits the center of the mirror. Adjust
the radar positioning bolt so that the refelction point falls onto the center of the center
of the scale of the magnetic laser.
9. Observe the on-screen prompt information and instructions to calibrate the radar
sensor.
*Note: While calibrating the radar sensor, you will be prompted to change to the
different hanging positions of the radar reflector. There are total 3 positions marked
with numbers (1, 2 & 3) for hanging on the cross member.
10. After calibrating the radar sensor, switch off the laser beam on the magnetic laser.

5.3.2 Calibrating the radar sensor without magnetic laser

Proceed as follows to calibrate the radar sensor without the magnetic laser:
1. Connect the diagnostic tool to the vehicle.
2. Launch the diagnostic App and select "Local Diagnosis" on the Job menu.
3. Follow the on-screen instructions to select the identified vehicle model and the
system to be calibrated.
A window with information and instructions appears.
49
X-431 ADAS PRO Calibration Tool User Manual