Supermicro X11DDW-L/NT User Manual page 103

sSATA Controller
This item enables or disables the onboard sSATA controller supported by the Intel PCH. The
options are Enable and Disable.
Configure sSATA as (Available when sSATA Controller is set to Enable)
Select AHCI to configure an sSATA drive specified by the user as an AHCI drive. Select RAID
to configure an sSATA drive specified by the user as a RAID drive. The options are AHCI
and RAID. (Note: This feature is hidden when the sSATA Controller item is set to Disabled.)
SATA HDD Unlock (Available when sSATA Controller is set to Enable)
Select Enable to unlock sSATA HDD password in the OS. The options are Enable and Disable.
sSATA RSTe Boot info (Available when Configure sSATA as is set to RAID)
When this feature is set to Enable, the SATA Controller provides full int 13h support for SATA
controller attached devices. CSM storage OPROM policy should be set to legacy to make
this selection effective. The default options are Disable and Enable.
Aggressive Link Power Management
When this feature is set to Enable, the sSATA AHCI controller manages the power use of the
sSATA link. The controller will put the link in a low power mode during an extended period of
I/O inactivity and will return the link to an active state when I/O activity resumes. The options
are Disable and Enable.
sSATA RAID Option ROM/UEFI Driver (Available when Configure sSATA as is set to
RAID)
Select EFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Disable, EFI, and Legacy.
sSATA Port 0 - sSATA Port 5
Hot Plug
Select Enable to support Hot-plugging for the device installed on an sSATA port specified by
the user which will allow the user to replace the device installed in the slot without shutting
down the system. The options are Enable and Disabled.
Spin Up Device
This setting allows the SATA device installed on the SATA port specified by the user to
start a COMRESET initialization when an edge is detected from 0 to 1. The options are
Enable and Disable.
sSATA Device Type
Use this feature to specify if the device installed on the sSATA port specified by the user
should be connected to a Solid State Drive or a Hard Disk Drive. The options are Hard
Disk Drive and Solid State Drive.
105
Chapter 4: UEFI BIOS