Supermicro X11DDW-L/NT User Manual page 102

Super X11DDW-L/NT User's Manual
SATA HDD Unlock (Available when SATA Controller is set to Enable)
Select Enable to unlock SATA HDD password in the OS. The options are Enable and Disable
SATA RSTe Boot info (Available when Configure SATA as is set to RAID)
When this feature is set to Enable, the SATA Controller provides full int 13h support for SATA
controller attached devices. CSM storage OPROM policy should be set to legacy to make
this selection effective. The default options are Disable and Enable.
Aggressive Link Power Management
When this feature is set to Enable, the SATA AHCI controller manages the power use of the
SATA link. The controller will put the link in a low power mode during an extended period of
I/O inactivity and will return the link to an active state when I/O activity resumes. The options
are Enable and Disable.
SATA RAID Option ROM/UEFI Driver (Available when Configure SATA as is set to
RAID)
Select EFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Disable, EFI, and Legacy.
SATA Port 0 - SATA Port 7
Hot Plug
Select Enable to support Hot-plugging for the device installed on a selected SATA port
which will allow the user to replace the device installed in the slot without shutting down
the system. The options are Enable and Disable.
Spin Up Device
When this feature is set to Enable, the SATA device installed on the SATA port specified by
the user will start a COMRESET initialization when an edge is detected from 0 to 1. The
options are Enable and Disable.
SATA Device Type
Use this feature to specify if the device installed on the SATA port specified by the user
should be connected to a Solid State Drive or a Hard Disk Drive. The options are Hard
Disk Drive and Solid State Drive.
PCH sSATA Configuration

When this submenu is selected, the AMI BIOS automatically detects the presence of the
sSATA devices that are supported by the sSATA controller and displays the following items:
104