Where To Place Unit; How To Stabilize The Unit; Starting Up Bike Console - CYBEX V Series Assembly Instructions Manual

Where to Place Unit

Read the entire manual before setting up the bike. After following all Safety Instructions, move the bike to the
location where it will be used. Allow a clearance of 2 ft. (0.6 m) in the directions the bike is accessed from and 3 ft.
(1 m) between the front or rear of the bike or any other objects.
Free area

How to Stabilize the Unit

After placing the unit in position, check the unit's stability by attempting to rock it from side to side. Any slight
rocking indicates that the unit must be leveled. Determine which foot is not resting completely on the floor. Loosen
the jam nut with an open-end M17 wrench and rotate the stabilizing foot to lower it. Verify that the bike is stable,
and repeat the adjustment as necessary until the unit no longer rocks. Lock the adjustment by tightening the jam
nut against the stabilizing bar.
Note: Stabilize the bike each time the unit is relocated.

Starting Up Bike Console

When a user begins pedaling, the unit's Auto-Start feature powers up the console, causing the console display to
light up and the MESSAGE CENTER to flash a prompt: "SELECT WORKOUT USING ARROW KEYS OR PRESS QUICK
START." If the user does not make a selection in 20 seconds, the console automatically starts a MANUAL workout.
If the user stops pedaling for more than 15 seconds, the console shuts down. Alternately, the user may press the
POWER ON key to power up the console.
Item
1
2
Page 9 of 26
Description
Jam Nut
Stabilizing Leg