Selecting Installation Position; Recommended Clearances; Installation; Installation Method - Carrier 40VM900010 Installation And Operating Instructions Manual

SELECTING INSTALLATION POSITION

Read this manual carefully before installing the interface
and keep the manual for future reference. The DLS VRF
interface should be installed as close as possible to the
Ductless indoor unit. Avoid installing DLS VRF interface
near high voltage components and heat generating devices.
Follow the local code for wiring methods between DLS
unit, VRF touch screen central controller, and DLS VRF
interface. Make sure the cover of DLS VRF interface is
installed after wiring to avoid any moisture or dust
accumulation.
Do not install the controller in a place exposed to water or in
a condensing environment.
Do not install the device in a location where there is direct
sunlight or where the temperature may become greater than
118°F(48°C) or less than -4°F(-20°C).
This product is neither waterproof nor dust proof, so it can
only be installed indoors.
NOTE: The communication wire should be 2-core stranded
shielded 18 AWG cable.

RECOMMENDED CLEARANCES

min. 2 inches
es
min. 2 inch
6 inches or more
Fig. 2 —Mounting Clearances

INSTALLATION

Installation Method

1. Use screwdriver to remove screw (2) of the box cover.
2. Slide and lift up the box cover as shown below.
3. Use the mounting screws (3) in the accessory bag to
min. 2 inches
4. Follow the wiring instruction for power and
3
mount the controller on the wall or solid surface as
shown below.
communication before installing cover back on the box.