Wet Vacuuming; Dry Vacuuming; Blowing Function - Black+Decker WV1450 Original Instructions Manual

2. Sofa brush
You can use this to clean the dust from books or sensitive
objects such as picture frames etc.This nozzle is suitable for
the careful cleaning of upholstered furniture, mattresses,
cushions, curtains etc. (figure 8)
Figure 7
3. Crevice nozzle
This nozzle is suitable for sucking and cleaning the corners
or niches that cannot be reached with the floor brush.
Besides, it can be used as blowing tool. (figure 9)
Figure 9
Attention!
1. Make sure all the assembly is according to the
instructions. Connect the hose to the unit, then install
the specific accessories for the intended cleaning
purpose.
2. Pull the cable to suitable length,insert the plug into the
socket. Press the ON/OFF switch button , start the
using.
3. After using, press the ON/OFF switch button to stop .
Unplug the cable from the socket.Then press the cord
rewind button to roll back the cable steadily .(figure 10)
Note: If the cable can not rewind completely,please pull
out the cable a little bit and press the rewind button
again.You can repeat the rewind steps until the cable is
rewind completely.
Switch button
Figure 8
Cord rewind
Figure 10
(Original instructions)

Wet vacuuming

Caution: Always remove the dust bag when you are
commencing wet vacuuming.
1. When picking up small amounts of liquid the HEPA filter
may be left in place.
2. When picking up large amounts of liquid we recommend
that the HEPA filter be removed.If the HEPA filter is not
removed, it will become saturated and misting may
appear in the exhaust.
3. When the liquid in the drum reaches a predetermined
level, the float mechanism will rise automatically to cut off
air-flow. When this happens , turn off the vac , unplug the
power cord, and empty the drum .
4. After using the vac to pick up liquids , the HEPA filter
must be dried to reduce the risk of possible mildew and
damage to the filter.

Dry vacuuming

Caution: Never dry-vacuum without the filter assembly
installed.
1. For dry–vacuum using, there are two filtering methods: 1)
dust bag; 2) HEPA filter. For mass dust cleaning, we
advise to use dust bag. For a bit but tiny dust cleaning,
we advise to use HEPA filter. Since the HEPA filter have
better filtering performance but will low down the air flow.
2. The device has dirt full and block indication function, the
light turns on that means the air routeway is blocked. In
this case, user should switch off the device and check:
1) Is the hose or accessories blocked by large dirt?
2) Is the filter blocked by dirt?
User should take actions:
1) Clean the dirt in the hose or other accessories.
2) Change or clean the dustbag (the HEPA filter).

Blowing function

The device has blow function, if necessary, fix the hose
connector to the exhaust of the device (the same method
with inlet connection), then fix the accessories to use.
(figure11)
Figure 11
ENGLISH
7