Manitou A Series Manual page 146

BLEEDING THE INJECTORS
- Loosen high pressure connectors 5 (Fig. G1/5) of two of the injectors.
- Activate the starter until the diesel fuel flows out free of air at connections 5 (Fig. G1/5).
- Tighten the connection while the diesel fuel is flowing out (Tightening torque 22 N.m).
The I.C. engine is then ready to be started up.
Turn the I.C. engine over slowly for 5 minutes immediately after bleeding the fuel feed
circuit, in order to ensure that the injection pump has been bled thoroughly.
NOTE : If the I.C. engine functions correctly for a short time then stops or functions
irregularly, check for possible leaks in the low pressure circuit. If in doubt,
contact your dealer.
G2 - W
HEEL
In the event of a wheel being changed on the public highway, make sure of the
following points :
- Stop the lift truck, if possible on even and hard ground.
- To pass on stop of lift truck (See chapter : DRIVING INSTRUCTIONS in paragraph : 1
- OPERATING AND SAFETY INSTRUCTIONS).
- Put the warning lights on.
- Immobilise the lift truck in both directions on the axle opposite to the wheel to be
changed.
- Unlock the nuts of the wheel to be changed.
- Place the jack under the flared axle tube, as near as possible to the wheel and adjust
the jack (Fig. G2/1).
- Lift the wheel until it comes off the ground and put in place the safety support under the
axle (Fig. G2/2).
For this operation, we advise you to use the hydraulic jack MANITOU Reference 505
507 and the safety support MANITOU Reference 554 772.
- Completely unscrew the wheel nuts and remove them.
- Free the wheel by reciprocating movements and roll it to the side.
- Slip the new wheel on the wheel hub.
- Refit the nuts by hand, if necessary grease them.
- Remove the safety support and lower the lift truck with the jack.
- Tighten the wheel nuts with a torque wrench (See chapter : A - DAILY OR EVERY 10
HOURS SERVICE in paragraph : 3 - MAINTENANCE for tightening torque).
CHANGE
3 - 41
G1/5
5 5 5 5
G2/1
G2/2