Clutch Lever - Yamaha XSR 700 Owner's Manual

Pass switch " "
Press this switch to flash the headlight.
TIP
When the dimmer switch is set
to " ", the passing switch has no ef-
fect.
Dimmer switch " / "
Set this switch to " " for the high
beam and to " " for the low beam.
Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch " "
Press this switch to sound the horn.
EAU12352
Start/Engine stop switch "
To crank the engine with the starter,
set this switch to "
the switch toward "
for starting instructions prior to starting
the engine.
Set this switch to "
gine in case of an emergency, such as
EAU12402
when the vehicle overturns or when the
throttle cable is stuck.
Hazard switch " "
EAU12461
With the key in the "ON" or "
"
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
". When
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
EAU12501
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
Instrument and control functions
EAU68270
/ / "

Clutch lever

", and then slide
". See page 5-1
" to stop the en-
1. Clutch lever
EAU12735
The clutch lever is located on the left
" posi-
side of the handlebar. To disengage
the clutch, pull the lever toward the
handlebar grip. To engage the clutch,
release the lever. The lever should be
pulled rapidly and released slowly for
smooth clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the igni-
ECA10062
tion circuit cut-off system. (See page
3-22.)
3-12
EAU12822
1
3