Mig Man Setup For Mig/Fcaw (Gmaw) - Pro-Tec Welding PRO-TEC 215 MP Operating Manual

4.12 MIG MAN Setup for MIG/FCAW (GMAW)

Danger! Protect Electric shock
yourself and can kill
others
NOTE 12: Wide safety margins provided by the design allow the Power Source will withstand short term overloads without
failure. The Welding Setup Data values should be used as a guide only then fine tune one or more of the Welding Setup Data
values to suit the welding application.
Before connecting the welding cables make sure the Input Power Supply is switched off. Remove any packaging ma-
terial prior to use. Do not block the air vents at the front or rear of the Power Source.
MIG MAN Setup Sequence
Refer to: - Section 4.9 Welding Wire Spool Setup: 4" (100mm)
- Section 4.10 Welding Wire Spool Setup: 8" (200mm)
- Section 4.11 Drive Roll Types and
- SECTION 5 – OPERATION
1 Switch the Power Switch (located on the rear panel)
to OFF position.
2 Connect the leads as follows:
a. Earth Clamp Lead to the Negative Output Termi-
nal for MIG or Positive Output Terminal for FCAW
b. MIG Gun Lead to the MIG Gun Adaptor.
c. 8 Pin Plug to 8 pin socket
d. Gas Hose to the Gas Input on rear panel then turn
ON the shielding gas.
DO NOT over tighten the gas fittings.
3 Plug the Power Source into Input Supply Voltage.
4 Switch the Mains Power Supply ON & Power Switch
(located on the rear panel) ON. This will immediately
energize the Power Source.
5 Rotate Knob then PUSH to SELECT
a. Welding Mode Selection
b. Welding Type Selection to 2T or 4T
6 Set Switch to MIG GUN & LINK to MIG or FCAW
located behind the Wirefeed Compartment Door.
7 Use Set Up Chart located on the door using Material,
Wire Type/Diameter, Shield Gas and Material Thick-
ness to set:
a. Wire Speed (Inch/Min
b. Voltage (V).
8 Commence welding.
9 If needed, adjust the Voltage ''V'' Control Knob.
10 If needed, adjust arc amperage by changing Wire
Speed ''Inch/Min '' to obtain the welding condi-
tion required.
11 If needed, adjust the Inductance Control Knob to fine
tune the welding arc.
12 Leave Power Switch ON for 3 minutes to cool down
internal components after welding completed.
13
Switch the Power Switch to the OFF position and
turn OFF the shielding gas.
POWER DOWN the Power Source by switching the machines Power Switch OFF then unplugging the Input Power Cord from the wall
socket or wall disconnect device. Use established Lockout/Tagout procedures, refer to OSHA 29 CFR 1910.147, when disconnecting
the Welder's Input Power Cord from the Input Supply Voltage.
© 2018 Global Welding LLC
Flying metal or Arc rays can
dirt can injure burn eyes and
eyes skin
Sizes.
for explanation of controls.
to MIG MAN
)
Page
Fumes and Welding can
gases can be cause fire or
hazardous explosion
Operating Manual No: PWOM-215/250MP-001
23
INSTALLATION
Improper instal- Read Operating
lation can cause Manual
fire