Subscribe to Our Youtube Channel
Related Manuals for IXXAT iPC-I 165/PCI
Summary of Contents for IXXAT iPC-I 165/PCI
- Page 1 Hardware Manual iPC-I 165/PCI Intelligent PC/CAN Interface The expert for industrial and automotive communication...
- Page 2 Internet: www.ixxat.de Internet: www.ixxat.com e-Mail: info@ixxat.de e-Mail: sales@ixxat.com Support In case of unsolvable problems with this product or other IXXAT products please contact IXXAT in written form by: Fax: +49 (0)7 51 / 5 61 46-29 e-Mail: support@ixxat.de Copyright Duplication (copying, printing, microfilm or other forms) and the electronic distribution of this document is only allowed with explicit permission of IXXAT Automation GmbH.
-
Page 3: Table Of Contents
3.2.1 CAN bus connection ...............10 3.2.2 Serial RS232C interface ............13 Appendix..................14 Technical data ................14 EMC information ..............14 Information for programming own firmware......14 Supply sources for data sheets..........15 Copyright IXXAT Automation GmbH iPC-I 165/PCI - Manual, Version 2.3... -
Page 5: Introduction
The aim of this manual is to help you familiarize yourself with your interface, also referred to in the following as iPC-I 165/PCI. Please read this manual before be- ginning with the installation. Features •... -
Page 6: Block Diagram
2. CAN AD 0..15 Controller Controller SJA1000/82527 SJA1000/82527 Microcontroller RESET SAB C165LM CAN bus CAN bus connection connection RS232 CAN High CAN bus CAN Low Fig. 1-1: iPC-I 165/PCI block diagram Copyright IXXAT Automation GmbH iPC-I 165/PCI - Manual, Version 2.3... -
Page 7: Installation
(5) Close the PC; the hardware installation is now completed. Software installation To operate the interface, a driver is required. For the installation of the CAN driver VCI under Win9x/Me/NT/2000/XP, please read the VCI installation manual. Copyright IXXAT Automation GmbH iPC-I 165/PCI - Manual, Version 2.3... -
Page 8: Configuration
Configuration 3 Configuration Plugs and jumpers The Figure 3-1 shows the positions of the plugs and jumpers on the interface. Fig. 3-1: iPC-I 165/PCI interface Copyright IXXAT Automation GmbH iPC-I 165/PCI - Manual, Version 2.3... -
Page 9: Bootstrap Loader
With JP10 closed the integrated bootstrap loader of the SAB C165 is activated after a hardware reset. The bootstrap loader is not necessary by using the iPC-I 165/PCI with IXXAT software. The bootstrap loader is described in detail in the data book of the Infineon SAB C165. -
Page 10: Pin Assignment
CAN bus connection One (common) or two independent bus connectors according to ISO/IS 11898-2 can be installed on iPC-I 165/PCI. The signals of the 1st bus interface are provided by the 9 pole sub-D plug/sleeve. If two independent bus interfaces are installed the signals for the CAN bus of the 2nd bus interface are provided by the connector JP19. - Page 11 Configuration CAN protection circuit As an option for iPC-I 165/PCI a CAN protection circuit is available containing a special CAN choke, a fast rectifier and a suppressor diode. The circuit keeps dis- turbances and short spikes on CAN lines away from the electronics of the iPC-I 165/PCI.
- Page 12 GND and VCC signals of the interface. If the CAN protection circuit is installed on the board the signals CAN low and CAN high of X9 (X11) are connected to X4/X5 (JP19) via the protection circuit. Copyright IXXAT Automation GmbH iPC-I 165/PCI - Manual, Version 2.3...
-
Page 13: Serial Rs232C Interface
SAB C165 serial interface via the port pins 3.10 and 3.11. Pin No. X3 Signal 2 4 6 8 10 1 3 5 7 9 Tab. 3-6: Pin assignment X3 Copyright IXXAT Automation GmbH iPC-I 165/PCI - Manual, Version 2.3... -
Page 14: Appendix
DIN EN 50082-2:02.96 EMC information The PC/CAN interface iPC-I 165/PCI has to be used only in a CE compliant PC. The case of the PC should be sealed up against high frequency electrical noise. Use only shielded cables for connecting the PC/CAN interface to the CAN bus and connect the cable shield to the connector case. -
Page 15: Supply Sources For Data Sheets
Appendix Supply sources for data sheets Dual-port-RAM IDT 71342LA: http://www.idt.com CAN controller Philips SJA1000: http://www.philips-semiconductors.com CAN controller Intel 82527: http:/www.intel.com Microcontroller Infineon SAB C165: http://www.infineon.com Copyright IXXAT Automation GmbH iPC-I 165/PCI - Manual, Version 2.3...
Need help?
Do you have a question about the iPC-I 165/PCI and is the answer not in the manual?
Questions and answers