SECTION 15—SEAT
FIGURE 15.9 Adjusting the Seat Depth - Adjustable ASBA Seats
Removing/Installing Side Rails
NOTE: For this procedure, refer to FIGURE 15.10 on page 97.
NOTE: This procedure applies to Adjustable ASBA seats only.
Removing Side Rails
1. Remove both armrests.
2. Remove the two hex screws, washer and lanyard securing the crossbars to the side rail.
3. Loosen, but DO NOT remove, the four hex screws securing the cane brackets to the
side rails.
4. Loosen, but DO NOT remove, the four hex screws securing the front arm sockets to
the side rails.
5. Use a screwdriver to gently tap the two roll pins out of the side rails.
™
Formula
PTO Plus Powered Seating
Cane
Bracket
Side Rail
Hex Screws
96
DETAIL "A" - SEAT
DEPTH
MEASUREMENT
Measure Distance
Front
Arm
Socket
Rear
Arm
Socket
Side Rail
Part No 1125031