Installing Model C - Dahua D Series User Manual

3.3

Installing Model C

Screw cover is available on select models.
For the installation diagram and item list of model C, see Figure 3-4 and Table 3-3.
No. Item
①
Mounting surface
⑤
Locking screw
Step 1 Drill screw holes (and the cable outlet hole if it needs to go through the mounting
surface) on the mounting surface① as indicated on the positioning map, then insert
expansion bolts② in the screw holes.
Step 2 Loosen the locking screws⑤ on the dome⑥ with the supplied wrench⑦ and take the
dome⑥ off.
Step 3 Adjust the location of the pedestal③ according to cable outlet requirement (top out or
side out), then pull the cable out through mounting surface or the side cable tray. Align
the screw holes on the pedestal③ to those on the mounting surface.
Step 4 Put the screw covers⑧ in the screw holes on the pedestal③, then put the supplied
self-tapping screws④ through the screw covers⑧ and fasten them to attach the
device to the mounting surface.
Figure 3-4 Model C installation diagram
Table 3-3 Model C installation item list
No. Item
②
Expansion bolt
⑥
Dome
No. Item No.
③ ④
Pedestal
⑦ ⑧
Wrench
Item
Self-tapping screw
Screw Cover
Installation 7