Step 5
Aim the lens to the ideal angle, and then adjust the focus and zoom until you get clear
image, see Figure 3-2. Fasten the fixing ring⑤ afterwards.
3.2
Installing Model B (1) and Model B (2)
No.
Item
①
Mounting surface
⑤
Device
Step 1
Loosen the locking screw⑥ with the supplied wrench and take the pedestal③ off.
Step 2
Confirm the position of screw holes (and the cable outlet hole if it needs to go through
the mounting surface①) and drill them on the mounting surface①, and then insert the
expansion bolts② in the screw holes.
Step 3
Align the screw holes on the pedestal③ to those on the mounting surface①, and then
pull the cable out through mounting surface or the side cable tray. Attach the pedestal
③ to the mounting surface① with the self-tapping screws④.
Figure 3-2
Figure 3-3
Model B (1) and Model B (2) installation
Table 3-2 Installation item list
No.
Item
②
Expansion bolt
⑥
Locking screw
Model A adjustment
No.
Item
③
Pedestal
⑦
Enclosure
No.
Item
④
Self-tapping screw
—
—
Installation 6