Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Dahua D Series
Summary of Contents for Dahua D Series
- Page 1 HDCVI Mobile Camera User’s Manual V1.0.1...
-
Page 2: Foreword
Foreword General This user’s manual (hereinafter referred to be "the Manual") introduces the functions, installation and operations of the camera. Safety Instructions The following categorized signal words with defined meaning might appear in the Manual. Signal Words Meaning Indicates a medium or low potential hazard which, if not avoided, could result in slight or moderate injury. - Page 3 official website. If there is inconsistency between paper User's Manual and the electronic version, the electronic version shall prevail. All the designs and software are subject to change without prior written notice. The product updates might cause some differences between the actual product and the Manual. Please contact the customer service for the latest program and supplementary documentation.
- Page 4 Important Safeguards and Warnings Electrical Safety All installation and operation should conform to your local electrical safety codes. The power source shall conform to the requirement of the Safety Extra Low Voltage (SELV) standard, and supply power with rated voltage which conforms to Limited power Source requirement according to IEC60950-1.
- Page 5 device is installed and maintained by professional engineers. The surface of the image sensor should not be exposed to laser beam radiation in an environment where a laser beam device is used. Do not provide two or more power supply sources for the device; otherwise it might damage the device.
-
Page 6: Table Of Contents
Table of Contents Foreword ..............................I 1 Introduction ............................1 1.1 General............................1 1.2 Features ............................1 2 Design ..............................2 2.1 Dimension ............................. 2 2.2 Cable ............................. 3 3 Installation .............................. 5 3.1 Installing Model A Series ....................... 5 3.2 Installing Model B .......................... -
Page 7: Introduction
Introduction General This series of products comply with the HDCVI standard and support the transmission of video and control signal over coaxial cable. They produce video signal with megapixel resolution and require HCVR device that comply with the HDCVI standard to achieve high speed, long distance and zero lag transmission of the signal. -
Page 8: Design
Design Dimension Figure 2-1 Model A (1) (mm [in]) Figure 2-2 Model A (2) (mm [in]) Figure 2-3 Model B (mm [in]) Figure 2-4 Model C (mm [in]) Design 2... -
Page 9: Cable
Figure 2-5 Model D (1) (mm [in]) Figure 2-6 Model D (2) (mm [in]) Figure 2-7 Model D (3) (mm [in]) Cable Cable type might vary with different cameras, and the actual product shall prevail. Figure 2-8 DC 12V Power Input Design 3... - Page 10 Figure 2-9 Video Output Figure 2-10 Aviation Port For more information about cable ports, see Table 2-1. Table 2-1 Cable information Port Name Function ① DC 12V Power Inputs DC 12V power. Please be sure to supply power as instructed in the Input Manual.
-
Page 11: Installation
Installation Make sure the mounting surface is strong enough to hold at least three times of the camera weight. Keep the protection film on the dome before installation and adjustment finished to avoid possible scratch. Properly handle the device after unpacking. Do not expose the device in humid environment. -
Page 12: Installing Model B
Installing Model B For the installation diagram and item list of model B, see Figure 3-2 and Table 3-2. Figure 3-2 Model B installation diagram Table 3-2 Model B installation item list Item Item Item Item ① ② ③ ④ Mounting surface Expansion bolt Pedestal... -
Page 13: Installing Model C
Installing Model C Screw cover is available on select models. For the installation diagram and item list of model C, see Figure 3-4 and Table 3-3. Figure 3-4 Model C installation diagram Table 3-3 Model C installation item list Item Item Item Item... -
Page 14: Installing Model D (1)
Step 5 Connect the camera to power source and HCVR, and aim the lens to the ideal angle, see Figure 3-5. Put the Dome⑥ back on and fasten the locking screws⑤. Figure 3-5 Adjusting Model C Installing Model D (1) For the installation diagram and item list of model D (1), see Figure 3-6 and Table 3-4. - Page 15 Table 3-5 Model D (2) and Model D (3) installation item list Item Item Item ① ② ③ Self-tapping screw Device Pedestal — — ④ ⑤ Expansion bolt Mounting surface Step 1 Drill screw holes on the mounting surface⑤, then insert expansion bolts④ in the screw holes.
-
Page 16: Configuration
Configuration Power up the camera and connect it to HCVR device with coaxial cable, then the main screen is displayed. The following instructions will guide you to configure your camera. The number of the coaxial port on HCVR will display at the lower left corner of each window to indicate the corresponding camera. - Page 17 Right-click anywhere on the screen to return to the previous menu until you goes back to main screen. Step 3 In the SETTING column area, click SYSTEM > PTZ. The Setting interface is displayed. See Figure 4-3. Figure 4-3 Setting interface Step 4 In the Channel list, select the camera that you want to configure according to the coaxial port number.
-
Page 18: Setting Audio Input
Setting Audio Input Audio signal acquisition is available on select models. Step 1 In the Main Menu interface (Figure 4-2), select CAMERA > ENCODE > Encode. The Encode setting interface is displayed. See Figure 4-4. Figure 4-4 Encode setting interface Step 2 In the Channel list, select the camera that you want to configure according to the coaxial port number. - Page 19 Step 3 Click to see more options. See Figure 4-6. Figure 4-6 PTZ setting options Step 4 Click The MENU OPERATION panel is displayed. See Figure 4-7. The OSD menu of the corresponding camera is displayed on the live view screen. Figure 4-7 Menu Operation panel For the function of the buttons in the MENU OPERATION panel, see Table 4-1.
- Page 20 Interfaces of different HCVR might vary, and the actual product shall prevail. The OSD menus of different cameras might vary, and the actual product shall prevail. Configuration 14...
-
Page 21: Maintenance
Maintenance In order to maintain the image quality and proper functioning of the device, please read the following maintenance instructions carefully and hold rigid adherence. Disassembly and Desiccant Replacement Carefully follow the instructions in the manual when performing any disassembly operation ...
Need help?
Do you have a question about the D Series and is the answer not in the manual?
Questions and answers