Panasonic FY-150ZDY8 Operation Instructions Manual page 18

安装参考图 施工方法
Installation of main unit and air duct
① Install 4 ceiling suspension bolts (separately buy:M10)
安装4个天花板吊装螺栓（另购：M10）
●Please align the suspension angle of main unit with ceiling suspension bolts.
请将主机吊装角度与天花板吊装螺栓对齐。
Suspension point dimension
●Please adjust the length of ceiling suspension bolt to ensure the distance between the downside of unit
and ceiling is over 25mm, the distance between the upside of unit and the mounting face of ceiling
suspension bolts is over 20mm.
请调整天花板吊装螺栓的长度，确保机器下部与天花板之间的距离应确保在25mm以上，机器上部与天花板吊
装螺栓安装面之间的空间应确保在20mm以上。
②Install the ceiling suspension part to its bolts.
将天花板吊装部件安装到其螺栓上。
●Please correctly install the direction of outside
air duct.
请正确安装外部风道的方向。
●Never fail to install the direction of unit
(ensure the ceiling suspension is above).
永远不要安装单元的方向（确保天花板吊装在
上面）。
●Fix the screws and washers (separately buy).
固定螺钉和垫圈（单独购买）。
●Install the unit horizontally.
水平安装设备。
Nut
螺母
Washer
垫片
Ceiling suspension part
吊装部件
18
施工方法
A
Model
吊装点尺寸
FY-150ZDY8
FY-250ZDY8
FY-350ZDY8
FY-500ZDY8
FY-650ZDY8
FY-800ZDY8
FY-01KZDY8A
above 20mm
20mm以上
above 20mm
20mm以上
安装主机和风道
Unit:mm
单位:mm
A B
型号
810 525
810 655
978 860
1018 960
1132 940
1250 940
1250 1190
③Seal the junction of an adaptor and a duct by
adhesive tape or seal tape (separately buy) to
prevent any air leakage.
用铝箔胶带（单独购买）密封接口和管道的连接部分，
以防止漏气。
●Please don't touch the fan motor by hand during
the air duct construction.
在风道结构中，请勿用手触摸风轮电机。
●Install the ducts (2) connected with outside shall
incline to outside. (gradient: 1/100~1/50)
安装与外部连接的管道（2）应向外倾斜。
(坡度: 1/100~1/50)
gradient
坡度
adhesive tape
铝箔胶带
●Conduct the insulation to outside of two ducts
connected with outdoor.
(suggested material: glass wool, thickness 25mm)
室外侧管道必须安装防止结露的绝缘材料。
(材料: 玻璃棉, 厚度25mm)
insulation material
绝缘材料
(Adaptor and aluminum tape is
requested to insulate.)
(接口、铝箔胶带也要求绝热)
outside air duct, exhaust air duct
室外新风管道，室外排风管道