Permobil ROHO AGILITY CARBON Operation Manual page 7

Hardware Selection Part One: Discs / Screws
Warnings:
- If the wrong hardware is used, the product will NOT fit correctly on the wheelchair. Follow these instructions to select the correct hardware.
Consult with a clinician or the equipment provider for assistance.
- If the product was provided already installed on your wheelchair, it is not necessary to select new hardware. However, if you are going
to remove the product and install it on a different wheelchair, make sure to follow all Hardware Selection and Product Installation and
Adjustment instructions before using the product.
Instructions: Select the correct discs and screws. Then, continue with "Hardware Selection Part Two: Outer Cane Clamps".
STEP ONE: Find the Back Shell
Width.
Refer to the label on the back shell and
the tables below.
Back Shell Width
14
15
16
17
18
14
15
16
17
18
14
15
16
17
18
ROHO AGILITY CARBON Contour Back Support Operation Manual
STEP TWO: Find the correct Width
Range:
Measure the distance between the
outsides of the wheelchair canes, as
shown. Refer to the tables below.
Width Range
cm in.
34.9 - 35.9 133/4 - 141/8
37.5 - 38.4 143/4 - 151/8
40 - 41 153/4 - 161/8
42.5 - 43.5 163/4 - 171/8
45.1 - 46 173/4 - 181/8
cm in.
35.9 - 36.8 141/8 - 141/2
38.4 - 39.4 151/8 - 151/2
41 - 41.9 161/8 - 161/2
43.5 - 44.5 171/8 - 171/2
46 - 47 181/8 - 181/2
cm in.
36.8 - 37.5 141/2 - 143/4
39.4 - 40 151/2 - 153/4
41.9 - 42.5 161/2 - 163/4
44.5 - 45.1 171/2 - 173/4
47 - 47.6 181/2 - 183/4
STEP THREE: Select Option 1, 2, or 3 (based on the Back
Shell Width and the Width Range).
Note: Each Option includes two (2) discs and one (1) screw for
each side of the back shell (total of 4 discs and 2 screws). Set
aside any remaining parts.
L
L
= Left Side
A
A
20mm
L
= Left Side
A
A
25mm
L
= Left Side
B
B
30mm
5
R
Option 1
R
= Right Side
A A A
A A A
Option 2
R
= Right Side
B B A
B B A
Option 3
R
= Right Side
B B B
B B B
20mm
25mm
30mm