Table of Contents
Advertisement
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1. Align the screw holes on the I/O board with the screw holes on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly.
3. Connect the fingerprint reader cable to the I/O board and close the latch.
NOTE:
Applicable only to computers that are shipped with power button with fingerprint reader.
4. Adhere the tape to the I/O-board cable.
5. Connect the I/O-board cable to the I/O board and close the latch.
Post-requisites
1. Replace the fan.
2. Replace the
base
cover.
40
Replacing the I/O board
Replacing the I/O board
computer. After working inside your computer, follow the instructions in
23
After
Advertisement
Table of Contents
