Table of Contents
Advertisement
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1. Align the screw holes on the fan with the screw holes on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x3) that secure the fan to the palm-rest and keyboard assembly.
3. Route the I/O-board cable and antenna cables through the routing guides on the fan and adhere the tapes to the fan.
4. Connect the fan cable to the system board.
5. Adhere the tape to the heat sink.
Post-requisites
Replace the
base
cover.
computer. After working inside your computer, follow the instructions in
Replacing the fan
Replacing the fan
17
After
31
Advertisement
Table of Contents
