NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
CAUTION:
Incorrect alignment of the heat sink can damage the system board and processor.
NOTE:
If either the system board or the heat sink is replaced, use the thermal pad/paste provided in the kit to ensure
that thermal conductivity is achieved.
Procedure (applicable only to computers shipped
with integrated graphics card)
1. Align the screw holes on the heat sink with the screw holes on the system board.
2. In sequential order (as indicated on the heat sink), tighten the four captive screws that secure the heat sink to the system board.
Procedure (applicable only to computers shipped
with discrete graphics card)
1. Align the screw holes on the heat sink with the screw holes on the system board.
2. In sequential order (as indicated on the heat sink), tighten the seven captive screws that secure the heat sink to the system board.
Replacing the heat sink
computer. After working inside your computer, follow the instructions in
29
After
Replacing the heat sink
49