GE Profile DFE Series Owner's Manual & Installation Instructions page 48

Troubleshooting Tips... Before you call for service
Problem
Beverage quality not as expected
Liquid drips from the brewer after
brewer cycle is completed and the
brewer is removed from the bracket
dispenser
After brewing, my powdered
beverage is not fully cleared from
the used pod
Brewer lid is difficult to close
Brewer leaks during the brew cycle
My refrigerator door squeaks
*Select Models Only
48
Possible Causes
You may be using non-standard or
retained by the brewer and drip
when it is removed
To ensure a quality beverage is
delivered, a short delay is required
to ensure the refrigerator is
operating correctly
powder may not dissolve fully.
Some powdered beverages develop
into 'clumps' when left sitting for
some time
Trouble in closing brewer lid or
accidental cleaning of the lubricant
on the hinge
assembled during installation
under Top Hinge cover may get out
of position and rub against door
while door swivels.
What to Do
have not been damaged
drips when brewer is removed
Ensuring consistent, quality operation
requires the refrigerator to delay
dispense for a short period of time
Shake the powdered pods before
brewing to break up these clumps and
beverage with no filter, use the Cocoa
cycle selection
brewer prior to closing the lid. Lower
closing the brewer lid
brewer prior to closing the lid. Lower
closing the brewer lid. Recommend
not been damaged and have a good
seal between the top cover and plastic
bottom
part number WR97X166 and apply on
the hinge at specified location.
lubricant such as silicone based non-
stick cooking spray, petroleum jelly or
MPORTANT:
will remove any remaining grease in or
around the hinge
Make sure the unit is leveled
Remove the Top Hinge cover and make
sure the waterline and harness that
passes through the hinge pin has been
properly seated and does not touch the
any of the door parts during rotation.
Applying some food grade lubricant
around door thimble area will also help.
49-60792 Rev. 4