GE Profile DFE Series Owner's Manual & Installation Instructions page 31

Installation Instructions
INSTALLING THE REFRIGERATOR (Cont.)
REMOVE FREEZER BASKET
4
Pull the lower basket and slide mechanism to
A
full extension using both hands.
Remove the top
B
fully extending the
drawer then lifting
up and out.
Remove the basket
C
resting on the
slides.
Push the bottom
basket slides back
until the slide mechanism self retracts.
5
REMOVE THE FREEZER
BASKET SLIDES
a doorway.
A
Remove the upper and lower baskets as
B
shown in Step 7.
Remove the clip on the crossbar
C
located along the right hand
side of the rack and pinion gear
assembly by sliding forward.
Remove crossbar by sliding to the right, then
pull out and to the left.
2
E
and remove side supports.
Hex head
bolts
49-60792 Rev. 4
5
G
6
A
Clip
1
REMOVE THE FREEZER
BASKET SLIDES (Cont.)
Reverse the steps to
assemble. When installing the
crossbar, always put the hole
on the right hand side. Align
the left and right gears with
the timing marks on the gears
when inserting the crossbar.
Always insert the crossbar in
the right hang gear first and
then the left hand gear.
2
hole located on the right hand
side.
RE-INSTALL FREEZER DRAWER
wheels onto the top of the track mounted to the
basket sides.
ON MODELS EQUIPPED WITH ICE MAKER
IN THE FREEZER: Place the ice bucket in the
the front of the bucket to the front of the basket,.
Make sure:
- The ice bucket does not hit the icemaker arm
- The fill tube extends into the fill cup opening at
the back of the icemaker.
Hole for clip
Timing
mark
1
Clip
31