GE Profile DFE Series Owner's Manual & Installation Instructions page 29

Installation Instructions
INSTALLING THE REFRIGERATOR (Cont.)
1
REMOVE THE REFRIGERATOR DOORS (cont)
E
screws securing the top hinge to the cabinet.
Screws
CAUTION
Lifting Hazard
Single person lift could cause injury. Use
assistance when handling, moving or lifting the
doors.
NOTE: when removing door, to prevent damage to
door and electronics, carefully place the door in a
proper location.
NOTE: The lower door hinge pin and hinge are keyed
and must be matched correctly for the door to self
close properly. Please follow the directions carefully.
NOTE: For proper installation later, please follow
the next step carefully.
Remove the tape and keeping the door as
straight as possible, open the door to 90º then lift
straight up to remove it.
Lift up & off
center hinge
49-60792 Rev. 4
REMOVE OPPOSITE DOOR
There are no water lines on the opposite side.
For Door in Door Models: Securely tape
the inner and outer doors before installing or
removing. 90º door alignment not required during
installation or removal for these models.
G REMOVE CENTER HINGE (if necessary)
Remove screws that secure hinge to the cabinet.
Remove
center screw
Loosen outer
screws
29