GE Profile DFE Series Owner's Manual & Installation Instructions page 5

IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
WARNING
The hot water dispenser is capable of heating water to a temperature of approximately 185°
temperatures above 125°
elderly are at highest risk of being scalded.
Use this appliance only for its intended purpose as described in this Owner's Manual. To reduce the risk of
severe burns, scald injuries, or death when using your hot water dispenser, the instructions below must be
followed:
during or after hot water dispense.
The hot water dispensing knob requires both twist and
push motions in order to reduce the risk of hot water
being dispensed unintentionally or by small children.
knob.
The water coming from the dispenser is very hot.
water. Allow water to cool to a drinkable temperature
before drinking. Your container should be close to
water.
When dispensing hot water, the container can become
paper or plastic may result in a burn while holding the
can cause the container to break and may result in
scalding or lacerations.
Always follow the formula manufacturer's instructions
for preparation of baby formula. When dispensing
temperature of the water before drinking.
READ AND SAVE THESE INSTRUCTIONS
49-60792 Rev. 4
HOT WATER DISPENSER
Scalding Hazard.
°
The first time the hot water feature is used, confirm if
This limits the temperature of the hot water system to
avoid boiling. To access the high altitude selection, go
to the settings menu if available or for other models
press Fridge and Door Alarm together to cycle from
Hi AL to Lo AL
A newly installed water filter cartridge will cause water
of water through the cold water dispenser (about 5
is removed from the system through the cold water
it may result in spurting of hot water and lead to hot
water scalding.
or of unknown quality.
The hot water dispenser is designed to only dispense
clean the tank.
factory replacement part only.
°
5