Advertisement
M) Tighten the Vertical Mounting Screw.
Position the Cutter Assembly so that
media will pass through the middle of the
Cutter Throat then tighten the top two
Long Mounting Screws. Next, loosen
the Vertical Mounting Screw one-half
turn then press down on the Lower
Mounting Block and tighten the bottom
two Long Mounting Screws. Retighten
the Vertical Mounting Screw. Then,
tighten the Short Mounting Screw and
the Thumbscrew.
N) Connect the Cutter Cable to the Cutter
Port, and then affix the Warning Label
(Item 12) to the Cutter Assembly, as
shown.
O) If removed from the applicator system,
reinstall the printer. Reconnect all
interface cabling.
Short
Mounting
Screw
Thumbscrew
Cutter
Assembly
Cutter
Throat
Cutter Port
Warning
Label
Cutter
Assembly
9
Vertical
Mounting
Screw
Long
Mounting Screw
(4 places)
Lower
Mounting Block
Cutter
Cable
Advertisement
