Advertisement
Overview
This document describes the contents and installation of the A-Class Mark II Cutter option. After verifying
the kit's contents and the tools needed, follow the steps to install and use the option. A maintenance
procedure and a parts list are also included, so keep this documentation for future reference.
Only qualified service technicians should install this option. For safety and to avoid
equipment damage, always turn 'Off' power and unplug the power cord before starting
CAUTION
this installation and when performing service.
Contents of the Cutter Kit
This kit contains the following items:
Mounting Bracket
1
2
Cutter CCA
Lock Washer (2)
3
Jack Screw (2)
4
Control Cable
5
Interface Cable
6
7
Screw (2), Flat Head M4 X 6
Cutter Assembly
8
9
Flat Washer (5)
10 Screw (4), M4 X 20
11
Screw, M4 X 10
12 Warning Label
Tools Required
To install this option, you will need a 3mm hex wrench, a 3/16-inch open-end wrench, a standard
screwdriver and a Philips screwdriver.
Wear a wrist strap and follow standard ESD prevention measures during this procedure.
CAUTION
2
5
3
4
6
8
7
3
1
11
WARNING
12
9
10
Advertisement
