Step 2: Installing The Option - Datamax A Class Mark II Installation Instructions Manual

E) Remove the two Service Panel Screws
then remove the Service Panel, and
remove the seven Rear Cover Screws
then remove the Rear Cover.

Step 2: Installing the Option

The following illustrations have the Rear Bracket removed for clarity. It is not nessacry to remove the Rear Bracket from your printer.
A) Starting from the back of the printer, insert
the Interface Cable (Item 6) through the
Centerplate Aperture.
B) Connect the Control Cable (Item 5) to
J17 on the Backplane CCA.
C) Snap the Interface Cable Connector
securely into the Cable Receiver in the
Access Cover.
Service
Panel
Service Panel
Screws
(2 places)
Centerplate
Aperture
Interface
Cable
Control
Cable
Access
Cover
5
Rear
Cover
Rear Cover
Screws
(7 places)
J17
Backplane
CCA
Cable
Centerplate
Receiver
Aperture
Interface
Cable Connector