Step 1: Preparing The Printer - Datamax A Class Mark II Installation Instructions Manual

Step 1: Preparing the Printer

A) Turn 'Off' the Power Switch, unplug the
power cord from the AC Receptacle,
disconnect all interface cables and, if
necessary for total access, remove the
printer from the applicator system.
B) Raise the Access Cover and the Head
Lift Lever. Remove any media from the
printer then lower the Head Lift Lever.
C) If the Warning Label covers the Cable
Receiver in the Access Cover, remove
the Warning Label. (For the Cable
Receiver's location, see the illustration in
Step 2, part C.)
D) Remove the following items from the Card
Cage:
Remove the two Card Cage Cover
Screws then remove the Card Cage
Cover;
Remove the two Main Logic CCA
Screws then remove the Main Logic
CCA; and,
Remove the two Applicator Interface
CCA Screws then remove the Applicator
Interface CCA.
AC
Receptacle
Power Switch
Access Cover
Head Lift Lever
Warning
Label
Card Cage
Main Logic
CCA
Main Logic
CCA Screws
(2 places)
Card Cage
Cover
4
Access
Cover
Applicator
Interface CCA
Applicator
Interface CCA
Screws
(2 places)
Card Cage
Cover Screws
(2 places)