Advertisement
D) Route the Interface Cable across the top
and then down the side of the Drive
Motor, as shown.
E) Route the Control Cable down the Cable
Bundle and secure it using the twist ties.
F) Place the Cutter CCA (Item 2) into the
Mounting Bracket (Item 1) then install
the Lock Washers (Item 3) and Jack
Screws (Item 4), as shown. Securely
tighten the Jack Screws.
G) Secure the assembled Mounting
Bracket to the Rear Bracket using the
Mounting Screws (Item 7).
Interface
Cable
Drive
Motor
Control
Cable
Mounting
Bracket
Jack
Screws
Lock
Washers
Cutter CCA
Rear Bracket
Mounting
Bracket
(assembled)
6
Cable
Bundle
Mounting
Screws
Advertisement
