Advertisement
J) Align the Tabs on the Rear Cover to the
Slots in the Centerplate then slide on the
Rear Cover. Secure the Rear Cover
using the seven Rear Cover Screws (3
hex and 4 Philips screws).
K) Replace the Service Panel and secure it
using the two Service Panel Screws.
L) Align the Cutter Assembly (Item 8) to the
holes in the Centerplate and install the
four Washers (Item 9) and Long
Mounting Screws (Item 10). Also install
the Washer (Item 9) and Short Mounting
Screw (Item 11). However, do not tighten
these screws – leave them loose enough
to allow the Cutter Assembly to be
positioned.
Centerplate
Service
Panel Screws
(2 places)
Service
Panel
Rear
Cover Screws
(7 places)
Short
Mounting
Screw
Washer
Cutter
Assembly
Mounting Screw
(4 places)
8
Tabs
Rear
Cover
Centerplate
Washer
(4 places)
Long
Slots
Advertisement
