Advertisement
Step 3: Using the Option
During operation, cut labels will be dispensed after printing. Be sure to use media that is rated for use with
the Cutter (see "Cutting Requirements," near the end of this document). Begin using the option as follows:
A) Load Media (see the Operator's Manual for
loading details). Then, route the Media out the
Cutter Opening.
B) Plug the power cord into the AC Receptacle and
turn 'On' the Power Switch.
C) Ensure that READY is displayed on the front panel then press the FEED Key, and proceed according
to your observations:
If a cut label is dispensed, this completes the installation; or,
If the label feeds forward without being cut, proceed to Step 4: "Configuring the Printer."
Cutter
Throat
10
Media
Advertisement
