Advertisement
3) Remove the two Cover Screws from the Cutter
Assembly and then remove the Cover.
4) Using compressed air, remove any debris trapped
inside the mechanism. Using a Cotton Swab
dampened with alcohol, wipe the Fixed Blade
clean, and then slightly raise the Sled and wipe
the Moveable Blade clean.
Note: For cleaning heavy deposits from the blades, WD-40
adhesive remover) can be substituted for isopropyl alcohol – provided this substitute is
carefully and sparingly applied using a cotton swab. Never spray WD-40
substance) directly onto the assembly; severe damage can result.
5) While the Sled is raised, check the Pad Wick for
sufficient lubrication –– if dry, replace the Pad
Wick.
6) Allow both blades to dry. Replace the Cutter Cover, and then secure it to the Cutter Assembly
using the two Cover Screws.
7) Place the Cutter Assembly onto the Mount. Then, replace the Vertical Mounting Screw and the
Thumbscrew; tighten both to secure the Cutter Assembly to the printer.
8) Reconnect the Cutter Cable.
9) Reload Media and close the Access Cover to complete the procedure.
Cover
Screws
Moveable
Blade
Fixed
Blade
®
(or another non-damaging
12
Cutter Cover
Cutter Assembly
Sled
Cotton
Swab
®
(or a similar
Pad Wick
Advertisement
