Philips AVENT SCF334 Manual page 13

- Inform yourself about the local separate collection system for electrical and electronic products
and batteries. Follow local rules and never dispose of the product and batteries with normal
household waste. Correct disposal of old products and batteries helps prevent negative
consequences for the environment and human health.
Removing the disposable batteries
To remove the disposable batteries, see chapter 'Preparing for use', section 'Assembling the breast pump'.
Guarantee and support
If you need information or support, please visit www.philips.com/support or read the separate
worldwide guarantee leaflet.
Troubleshooting
This chapter summarises the most common problems you could encounter with the appliance.
If you are unable to solve the problem with the information below, contact the Consumer Care
Centre in your country or visit us online at www.philips.com/support.
Problem
I experience pain
when I use the breast
pump.
The breast pump is
scratched.
The breast pump does
not work and the on/
off button flashes.
I do not feel any
suction.
I need to replace the
silicone tube, but do
not know how to
remove it.
Solution
Stop using the breast pump and consult your breastfeeding advisor.
If the pump body does not come away easily from the breast, it may be
necessary to break the vacuum by placing a finger between the breast
and the massage cushion.
In case of regular use, some light scratching is normal and does not cause
problems. However, if a part of the breast pump becomes badly
scratched or if it cracks, stop using the breast pump and contact the
Philips Consumer Care Centre or visit www.shop.philips.com/
service to obtain a replacement part. Be aware that combinations of
cleaning agents, sterilising solution, softened water and temperature
fluctuations may, under certain circumstances, cause the plastic to crack.
Avoid contact with abrasive or antibacterial detergents as these can
damage the plastic.
First check if you have assembled the breast pump correctly and make
sure that there is no kink in the tube. If you are using SCF332 with
batteries, replace the batteries according to the instructions in chapter
'Preparing for use', action 5. If you are using SCF334 or SCF332 on mains
electricity, check to make sure you are using the adapter that was
supplied with the product. If the problem persists, contact the Consumer
Care Centre in your country.
Check if you have assembled the breast pump correctly by following the
steps in chapter 'Preparing for use'. Make sure the silicone tube is firmly
attached to the motor unit and to the cap and diaphragm.
To remove the tube, grab it close to the motor unit and pull while twisting
it. To reconnect the tube, ease the tube back onto the connector on the
motor unit with a slight twisting motion. Make sure it is securely attached.
ENGLISH
13