Table of Contents
Advertisement
Chapter
3
3.1
Installation
3.1.1 Installation Procedure
Before installing the GP into a cabinet or panel, check that the installa-
tion gasket is securely attached to the unit.
Rear of GP
Creating a Panel Cut
Create the correct sized opening required to install the GP, using the installation
dimensions given.
The installation gasket, installation brackets and attachment screws are all required when
installing the GP.
• Check that the installation panel or cabinet's surface is flat, in good condition
and has no jagged edges.
• Panel thickness should be from 1.6mm (0.06in.) to 5mm (0.2in.).
Decide the panel's thickness based on the level of panel strength
required.
GP-37W3 Series User Manual
Installation and Wiring
It is strongly recommended that you use the gasket since it
absorbs vibration in addition to repelling water.
Installation gasket
Place the GP on a level surface with the display panel facing
downward. Check that the GP's installation gasket is seated
securely into the gasket's groove, which runs around the
perimeter of the panel's frame. For details about installing
the gasket, refer to
2.5.3 "GP Panel Cut Dimensions"
Panel
Cut Out
Area
1. Installation
2. Wiring Cautions
3. Tool Connector
7.1.2 Installation Gasket Replacement
1.6mm(0.06in.) to 5mm (0.2in.)
3-1
Advertisement
Table of Contents
