fitted so that the bent section of the tube angles
toward the ground.
Figure 3
Left side shown
1. Cap
2. Hex locknut
3. Clamp plate
3.
Install the bottom of the brace handlebars to
each side of the mower deck using a bolt, flat
washers on the inside and outside of the deck,
and a locknut
(Figure
Figure 4
Left side shown
1. Hex locknut
2. Flat washer
4.
Install the upper handlebars and top of the brace
handlebars to the lower handlebars with 3 cup
washers, 2 bolts and 2 hex locknuts on each
side
(Figure
5).
g281281
4. Lower handlebar
5. Remove the hex nut and
install the lower handlebar
here.
4).
g281383
3. Brace handlebar
4. Bolt
Left side shown
1. Bolt
2. Cup washer
3. Lower handlebar
4. Upper handlebar
5.
Install caps over all of the exposed handlebar
nuts.
5
Figure 5
5. Brace handlebar
6. Hex locknut
7. Cap
g281404