Toro ProStripe 560 Operator's Manual page 11

Adjusting the Cutting Height Using
Matchcut
An additional 6 setting heights can be achieved using
the matchcut height setting. This feature allows the
height of cut selector plate to adjust by one half
setting.
1. Loosen the selector plate retaining bolt with an
Allen wrench (Figure
Figure 12
1. Retaining bolt
2. Turn the matchcut adjuster 180°
Figure 13).
Note:
An indicator will appear at the bottom of
the selector plate, highlighting when matchcut
is set.
12).
2. Matchcut adjuster
(Figure 12 and
1. Matchcut indicator
2. Selector plate
3. Tighten the selector plate retaining bolt to fix the
g281591
height of cut selector plate into position.
Height Setting (with
Matchcut)
1.5
2.5
3.5
4.5
5.5
6.5
11
Figure 13
3. Matchcut adjuster
Height of Cut
16.9 mm
24.8 mm
32.6 mm
40.4 mm
48.3 mm
56.1 mm
g281590