Setup; Assembling The Handle - Toro ProStripe 560 Operator's Manual

134-3333
1. Quick-wash port
133-8062

Setup

Important:
plastic sheet that covers the engine.
1

Assembling the Handle

decal134-3333
Parts needed for this procedure:
2 Lower handlebar (left)
2
Lower handlebar (right)
2 Clamp plate
2 Short bolt
decal133-8062
4 Flat washer
6 Locknut
4
Cup washer
4 Long bolt
1 Upper handlebar
6 Cap
Procedure
WARNING
Assembling the handle improperly can
damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when
assembling the handle.
• Ensure that the cables are routed to the
inside of the handle and do not catch the
rear deflector.
• If a cable is damaged, contact your
Authorized Service Dealer.
1. Remove the hex nuts from the 2 exposed bolts
on the top of the deck.
2. Install a lower handlebar to each side of the
top of the mower deck with a clamp plate and
the hex locknut removed from the deck in the
previous step
Note:
along the midsection; ensure that the tubes are
4
Remove and discard the protective
(Figure 3).
The lower handle tubes have a bend