System Power Up; Set-Up Mode; Introduction - Pace Sodrtek ST 145 Operation And Maintenance Manual

1. Place the ST 25/45 system adjacent to (side by side) or stacked on top of your ST 125/145
system.
2. Use the TEKLINK cable (sold separately) to connect the systems together. The TEKLINK
Receptacle is located on the back panel of each power supply.
3. Ensure the VisiFilter assembly is connected to either the ST 125/145 VACUUM Port.
4. Connect the air hose of the handpiece being used, to either the VisiFilter assembly or the
controllable PRESSURE port.
The TEKLINK Remote Box (sold separately) allows the connection of up to three ST 25/45 systems in
any combination.
NOTE: Systems connected together through the TEKLINK system must be used and controlled by a
single operator. Any attempt to operate by more than one individual can create a hazardous
condition and will cause deterioration in performance.

System Power Up

1. Insert the female end of the power cord into the AC Power Receptacle on the rear panel of
the power source.
2. Plug the prong end (male end) of the power cord into an appropriate 3 wire grounded AC
supply receptacle.
CAUTION: To insure operator and ESD/EOS safety, the AC power supply receptacle must be
checked for proper grounding before initial operation.

Set-Up Mode

PACE recommends that you not read the "Set-Up Mode" section until after you feel comfortable with
system operation. Please read the following "Operation" section thoroughly before changing the system
settings.

Introduction

The menu driven LED Display of the ST 145 system in the Set-Up Mode allows you to easily
customize your system. No calibration adjustments are necessary to maintain the accuracy of the
system. In Set-Up Mode, you can:
1. Enter, remove or change a Password.
2. Set the Default Temperature scale to °F or °C as desired.
3. Change the Upper and Lower Temperature limits.
4. Enter a Temperature Offset Constant (Auto Tip Temperature Compensation).
5. Enable or disable the Temperature Setback feature and adjust the timeout period (if
enabled).
6. Enable or disable the Auto Off feature and adjust the time-out period (if enabled).
©2004 PACE Inc., Annapolis Junction, Maryland
All Rights Reserved
Page 7 of 22