Table of Contents
Advertisement
Auto Off
13. The LED Display now shows the stored Auto Off time as "AOx" (x=0 thru
9). Time is shown as tens of minutes (e.g., "AO3" equals 30 minutes). A
display of "AOO" indicates that Auto Off is disabled. Choose one of the
following:
a) Press and release the Program (
b) Press and release the Scroll Up
and release the Program (
c) Press and release the Scroll Down
time. Press and release the Program (
Temperature Display Impedance
14. The LED Display now shows the Temperature Display Impedance mode as
Enabled or Disabled ("AC0" = Disabled and "AC1" = Enabled). Choose
one of the following:
a) Press and release the Program (
or Enabled).
b) Press and release the Scroll Up Key to change the stored setting (Disabled or Enabled).
Press and release the Program (
Exiting Set-Up Mode
15. The LED Display now reads "End". The Set-Up Mode procedure is now
complete. Choose one of the following steps:
a) Press and release the Scroll Up
return to normal operation.
b) Press and release the Scroll Down
Set-Up Mode procedure.
Heater Burn In Procedure
Use the following instructions to perform the Heater Burn In procedure.
NOTE: Ensure that the system is placed in a well-ventilated area. Smoke will be generated during
the burn in cycle and while soldering. Fume extraction equipment is recommended.
1. Place the Power Switch in the "OFF" (0) position.
2. Ensure that the handpiece is connected to the power source. If a plastic cap is present on
the heater assembly, remove it and discard. The cap is used for shipping purposes only.
3. Press and hold the Program (
4. Place Power Switch in "ON" (I) position.
©2004 PACE Inc., Annapolis Junction, Maryland
All Rights Reserved
) Key to keep the currently stored Auto Off time.
Key to enable and/or increase the Auto Off. Press
) Key to proceed to the next step.
Key to decrease or disable the stored Auto Off
) Key to proceed to the next step.
)
Key to keep the currently stored setting (Disabled
)
Key to proceed to the next step.
Key to exit Set-Up Mode and
Key to return to the start of the
) and Scroll Up
keys together.
Page 10 of 22
Advertisement
Table of Contents
