Factory Settings; Definitions - Pace Sodrtek ST 145 Operation And Maintenance Manual

Desoldering system
Table of Contents

Advertisement

Factory Settings

The ST 145 system comes equipped with a number of features which may be
adjusted, enabled or disabled as desired by the user. Listed below are the features
and factory settings of each. To change and/or learn about any of these features,
refer to the applicable part of the "Set-Up Mode" portion of this manual.
FEATURE
Password
Default Temperature Scale (°C/°F)
"Hi L" (upper) Temperature Limit
"LO" (lower) Temperature Limit
Set Temperature
Tip Offset Constant
Temperature Setback
Setback Time
Auto Off
Time To Auto Off

Definitions

Please read and become familiar with the definitions of each of the following terms which are used
repeatedly in the following operational procedures.
AUTO OFF - Safety feature which turns power off (10-90 minutes, settable in 10 minute increments)
after the system has entered Temperature Setback.
NORMAL OPERATION - Normal operating mode of the system in which the Operating Tip
Temperature is displayed.
OPERATING TIP TEMPERATURE - The true tip temperature at which the handpiece tip operates at
any given time.
SET TIP TEMPERATURE - The operator selected idle tip temperature entered into the system
memory.
SET-UP MODE - Mode of operation in which the operator can quickly and easily adjust the system
parameters (e.g., temperature limits, password, setback time).
TEMPERATURE ADJUST MODE - Mode of operation in which the operator can quickly and easily
adjust the Set Tip Temperature.
TEMPERATURE DISPLAY IMPEDANCE (TDI) MODE - Stabilizes the tip temperature shown on the
LED Display by ignoring minor temperature fluctuations. Displayed changes in temperature are
delayed (impeded) for two seconds when a load is applied to the tip. Two seconds after the load is
removed, the displayed temperature will begin rising to set temperature. Particularly useful in a
©2004 PACE Inc., Annapolis Junction, Maryland
All Rights Reserved
FACTORY SETTING
None Entered
°F for 115V Systems
°C for 230V Systems
482°C (900°F)
204°C (400°F)
"OFF"
"0"
Enabled
30 Minutes
Enabled
30 Minutes
Page 19 of 22

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sodrtek st 145e

Table of Contents