Silvercrest STV 45 E1 Operating Instructions And Safety Instructions page 8

SilverCrest STV 45 E1
•
Should liquid enter the product, immediately remove the plug
from the socket. Have the product examined by a qualified
specialist before using it again.
• Do not handle the product with wet or damp hands.
•
Do not reach for the product if it is in water or any other liquid.
In such cases, immediately remove the plug from the socket.
• Do not use the product if the plug or the connecting cable are
damaged, if it does not operate as intended, if it has been
dropped on the floor or in water or if it exhibits any other
damage. In such cases, contact a qualified specialist for repair.
• Only connect the plug to a socket that has been properly
installed, is easily accessible and the mains voltage of which
corresponds with the information specified in the 'Technical
data' section. The socket must continue to be easily accessible
after the plug has been connected.
• Ensure that the connecting cable cannot be damaged by sharp
edges or hot surfaces.
• When using the product, ensure that the connecting cable is not
jammed or squashed.
• The product is also not fully disconnected from the power
supply once it has been switched off. Remove the plug from the
socket to fully disconnect it from the power supply. Always pull
at the plug to remove it from the socket; never pull on the cable.
• Remove the plug from the socket
o if a fault occurs,
o if you are not using
during assembly,
o
6 - English
the product,