Voicetron - KETRON Audya Series User Manual

Voicetron

The Voicetron section has one volume fader for
MICRO and one volume fader for VOCALIZER,
both with on/off LED button. Once you connect
a microphone to the MICRO 1 connector and/or
MICRO 2 connector, you can access to a wide
range of options for the voice processing.
▀ MICRO
The MICRO button enables both MICRO 1 and
MICRO 2 inputs. Connect one or two dynamic
microphones to the connectors on the rear panel
and adjust the gain level by using the GAIN 1 and
GAIN 2 small knobs on rear panel.
▀ VOCALIZER
The VOCALIZER button enables the multi-
processor effects for harmonization and
automatic pitch control only on MICRO 1 input.
▀ Setting a vocal effect
1. Press and hold for few seconds MICRO button.
2. The screen where to choose the MICRO
PRESETS will appear
3. Press the F1-F10 buttons to set one of the MICRO
PRESETS, that is an effect for the microphone
connected to MICRO 1 and/or MICRO 2 input.
4. Press the CURSOR Ó Á to scroll the MICRO
PRESETS pages.
By pressing the F1-F10 buttons you can
access two pages with ten MICRO PRESETS
each:
PAGE 1
F1–DRY
F2–REVERB SMALL
F3–REVERB MEDIUM
F4–REVERB LARGE
F5–REVERB GATED
F6–BOOST
F7–ECHO REVERB
F8–ECHO REVERB TAP F8–MICRO_03
F9–CORRECTION
F10–BEAR
B
(Figure 51).
PAGE 2
F1–GIRL
F2–BABY
F3–VIBRATO
F4–PHONE
F5–ANGEL
F6–MICRO_01
F7–MICRO_02
F9–MICRO_04
F10–MICRO_05
NOTE
To access the configuration menus of MICRO and
VOICETRON, hold down few seconds the corresponding
buttons.
Figure 51
NOTE
Audya microphones input allows to use only Dynamic
Microphones.
Voicetron
37
KETRON • AUDYA