Msp Function - KETRON Audya Series User Manual

MSP
Audya offers a complete Multi Sample Player
editor. To access the MSP function, press the
WAVE button, choose a file from the list in the
WAVE folder and press the EDIT button.
▀ Creating an MSP
1. Select a WAV format file from the WAVE folder
and press ENTER to load the file into memory
(Figure 245). By using the F1-F10 buttons you
can access the following functions:
F1 - START: sets the start of the note range on
the keyboard. Press a button on the keyboard for
the automatic assignment
DATA/VALUE wheel or the CURSOR Ó Á .
F2 - END: sets the end of the note range
247) as described above.
F3 - KEY: sets the basic pitch. Press a button on
the keyboard for the automatic assignment .
F4 - PITCH: it can be TRACKING, that is tuned
for each button of the keyboard, or FIXED, that is
with fixed pitch for any keys of the keyboard.
F5 - FINE: fine tuning of the sound up to +99
cents of a semitone.
F6 - VOL: sets the output volume.
F7 - CUTOFF: sets the cutoff frequency (low-cut
filter).
F8 - EP (END POINT): sets where the sound ends.
F9 - LP (LOOP POINT): sets where the sound
loops.
2. By using the USER 1 button (PAGE >>) you can
jump to a further screen to edit the parameters
of the sample (Figure
buttons you can access the following functions:
F1 - ATTACK: sets the attack time of the envelope.
F2 - DECAY: sets the decay time of the envelope.
F3 - SUSTAIN: sets the sustain level of the
envelope.
F4 - RELEASE: sets the release time of the
envelope.
F6 - SLOPE: sets the slope of the envelope.
F7 - OFFSET: sets the amount of the envelope
accordingly to the dynamics.
F8 - FILT. SLOPE: sets the filter slope.
F9 - FILT. OFFSET: sets the amount of offset on
the filter accordingly to the dynamics.
3. Load another WAV file, assign it to another button
and repeat editing.
4. When you select all the desired WAV files you
can see the list of the files loaded into MSP by
pressing the MSP VIEW button (USER 2 button).
In this screen you can check the files out, remove
files (USER 3 button) and play a file by using the
SOLO button (USER 4 button). This environment
lets you ri-edit the previously created MSP files.
By pressing the MSP VIEW button again you exit
to the main window.
(Figure 246) or use the
(Figure
248). By using the F1-F10

MSP function

Figure 245
Figure 246
Figure 247
Figure 248
KETRON • AUDYA
99