Sony NYSNO-10 Help Manual page 16

Help Guide
Helmet Mounted Wireless Headset
NYSNO-10
Attaching the main unit to a helmet
Helmets suitable for NYSNO-10
The main unit can be attached to helmets for winter sports. Check if the following conditions are met in the central area
on the rear side of the helmet, other than the area where the goggle belt and fixed parts are located.
There is no irregularity in the area where the adhesive mount will be stuck (46 mm (1.81 in.) in diameter).
There is no protrusion in the area where the main unit will be attached (length 52 mm × width 143 mm (2.05 in. ×
5.63 in.)).
Determine the attaching position.
1
Put the main unit on the helmet with the adhesive mount attached to the main unit and determine the area
1.
where the sticking surface has no gap.
Remove the release paper and press the whole main unit securely against the area you determined in step 1.
2.
To ensure that the adhesion strength is sufficient, check that the sticking surface has no gap.
Detach the main unit and fix the adhesive mount.
2
Turn the lock lever in the direction of the arrow as illustrated and detach the main unit leaving the adhesive
1.
mount.
16